![]() However, once you are done, you will be left with a much stronger WiFi signal. Just like with the cardboard box method, you will have to experiment a little bit to get the right positioning and shape. Repeat the above steps if you have multiple antennas.Use the soda can hole to push the antenna through.Cut most of the top part off but leave a small piece on so that you can open up the soda can.Be very careful because both the aluminum and the tool you are using are very sharp Cut off the bottom part using a knife, scissors, or a hacksaw.Thoroughly wash the can using soap and water and then rinse it.This method is easy if you have a good pair of scissors or even better a hacksaw. Again, your router should ideally be placed in the corner of your house to get the best results. So, if you do not have any aluminum foil or maybe you do not like the aluminum box esthetic, you can use soda (or beer) cans instead. No Aluminum Foil? Use an Empty Soda Can Instead! But how to increase WiFi with aluminum foil if you don’t have any aluminum foil in the first place? Luckily, you can follow the next method. Some people say that they get an incredible 40-50% boost in signal strength after they are done. Now that you know how to increase WiFi signal with aluminum foil, it’s time to test the before and after results using a speed test app. You can cut the sides of the box to open it up and get an even better signal Once you are done, experiment with the positioning to get the best signal.You can cut holes in the box so that the antennas can pass through it This works best if your router is in the corner of your house. Cover both Antennas with the box but make sure that the open end of the box is facing the rest of your house.Cover all inside surfaces with aluminum foil and use tape or some sort of glue to hold it all together You can use your router’s box for this or make your own using cardboard. You first have to stick aluminum foil inside the box. ![]() Without any further ado, here is how to use tin foil to boost WiFi signal: There are only a few things that you have to do, but you may have to redo it a few times before you get the right shape and positioning. Once you got all the things you need for this project, you are all set.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |